Looking beyond intelligence: how to install ESD anti-static access control system

ESD anti-static access control system how to properly install, should pay attention to the following questions:

First, ESD anti-static access control system to determine the program.

In the communication with the customer to determine the program, the site width, length, how many units can be clearly installed, is the choice of vertical ESD anti-static access control system, or bridge ESD anti-static access control system, vertical ESD anti-static access control system dimensions : 420x330x980(mm), Bridge ESD Anti-Static Access Control System Dimensions: 1200x280x1000(mm),, ESD Anti-Static Access Control System Bar to Case Size 510mm, Vertical ESD Anti-Static Access Control System Area: 420x(330+510) ), Bridge ESD anti-static access control system covers an area of ​​1200x (280+510). When determining the type selection, fully consider the gap between the gate and the brake lever, and the occupied area of ​​each ESD anti-static access control system. How the cabling (whether it is to take the open line or take the dark line), the program is set, the goal is set, waiting for the ESD anti-static access control system to the scene.

Second, fixed position wiring.

According to the previously determined plan, the specific size of the ESD antistatic control system shall be clearly defined, and the pre-embedded pipe shall be provided. The gap between the gate and the gate shall be 50-100mm. The upper cover can be opened to prevent adjustment of the machine, maintenance, etc. Never leave gaps between the gates and gates. Two plastic pipes with 6 points and 8 points are embedded. One hose takes the power line (strong power). The other hose takes the signal line (weak current). The power line and the signal line take a rubber hose at the same time, which will affect the communication effect. The embedded pipe should be exposed to the ground with a height of 30-40mm. The vertical ESD ESD control system should be in the middle of the machine and the bridge should be ESD-proof. The electrostatic access control system should be on both sides (because the bottom of the bridge ESD antistatic control system is closed).

Third, fixed adjustments.

Fixed bottom is fixed with 4-M10x100 expansion screw, can not swing, the whole level, the overall appearance is consistent, it is best to use a thin line to pull a straight line before the fixed, vertical and horizontal consistent, overlooking the intelligent ESD anti-static access control system and ESD anti-static The access control system adopts a series connection method and adjusts one by one so that the straight line can be used normally.